Recent content by PunchySunshine

no gut shot? no deets on the mods? ...then it didn't happen :ROFLMAO:

Love My Switches

What mods are those switches up top?

Nate, I just finished building the wrecking ball and WOWSERS it’s good! I did have a couple of notes. First, the 4u7 25V cap from the build doc doesn’t seem to be needed as there isn’t a place for it on the board. Secondly, I used your artwork file (thank you for supplying) and Tayda sent me an...

Pads 5-9

Some of those solder connections look cold or dry. Here is a graphic to show the foot switch wiring off board, maybe it'll help with tracing. Post in thread 'Paragon footswitch brute trace lifting' https://forum.pedalpcb.com/threads/paragon-footswitch-brute-trace-lifting.16480/post-191843 I'm...

Clean as a whistle! Well done!

I would try it with the 12v output. It says it's good for 50 watts. Worth a shot, you can always return it if it doesn't work.

Correct

Works fine in my experience. i've got two in serial in the FX loop of a Deluxe 85.

Yes I did see that. PPCB forum wasn't able to load for a few hours.

100-150mV @ 1kHz is what I use.

According to your diagram, #2, #3 and #6 all need to be connected. I only see #3 and #6 connecting

Apologies, I had the wrong numbering scheme in my head. The shorting pins #7 and #8, according to this diagram:

On your footswitch, pins #3 and #6 look like they are shorting out.