Robert's latest activity

That's not it, this is the one: You can use this: https://www.taydaelectronics.com/680uh-inductor-ec36.html Or you can use a jumper...

It's for a Cliff FCR14422, it grounds the enclosure since the jacks are plastic and make no electrical contact. You only need one, not...

"We developed a custom turned brass knob to reduce vibrations in the shaft and wiper of the semi-fixed resistor used for each control...

The "method" .... seriously.

That's what this was. I'll have to see whats in the standard version next.

That's what we're calling it now when we take three absolutely essential components out of the circuit and place them on a little board...

Please.... "Ultimately, I added a drive circuit that uses a dedicated module before the normal channel circuit and adopted a method to...

Wait just a damned minute..... why doesn't this one have those custom knobs that improve the sound? I bet if I put the knobs off my...

I mean..... there was an opamp encapsulated in plastic for absolutely no good reason whatsoever.

Are you sure it was there before you started tracing? Maybe it's some new kind of protection? As soon as you start poking around, random...

They vary in size and aren't connected to ground (or at least not all of them). Some are in parts of the circuit where you typically...

This one has been a real treat. FTT goes above and beyond, as always. The (three) boards are littered with traces that go nowhere...

Finished using the last 2 of the 5 PCB's I got made up for the saturater. The first 2 builds are here PART 1, PART 2. This version has...

It was mentioned but I'm not sure that it has actually happened yet.

Yep I think that's right..... it's been almost two years since I plugged the pedal in, I can't remember what it does. :ROFLMAO: