Recent content by spi

Also, the google query site:pedalpcb.com filetype:pdf tl071 will bring up some of the build docs that have tl071 in them. Looks like one of the top hits (Celsius) is a 1-knob w/ a tl071, as is the Triangulum (both of these also have a chargepump too).

a microamp comes to mind https://tagboardeffects.blogspot.com/2010/08/mxr-micro-amp.html

It's not going to impact tone either way, but from the schematic, I'd probably use a 1n5817 there as it's part of the power section.

good point, I should've considered this, was being too simplistic. and you're right: it's a odd spec to claim.

The schematic says it all

The web site is annoying but I've built several guitarpcb offerings and they've all been solid.

These have saved me a few times (and they do break easily). They cost a buck at Tayda, well worth it.

I use scotch tape.

subscribed

I prefer ebay over reverb. I use an RV-6. It's fine for my needs. I also have all the Gravitation parts in my build queue/backlog, so eventually I'll try it out. I don't really want to go into a reverb hole searching for something better because reverbs are expensive.

See http://www.geofex.com/Article_Folders/fuzzface/fffram.htm and http://diy.smallbearelec.com/HowTos/FuzzFaceFAQ/FFFAQ.htm

that's brown sand? looks purple. maybe that's just my monitor though

Is that speaker wire for the battery connect? Beats the thin wires that I get with the tayda battery jacks.

that's what prevents me from buying a press. I just assume my holes will still be crooked.

12 range options? That's a lot. What values of caps will you use?