Search results

Pretty straight forward build and all went smoothly. Still have a bit of tuning to do but for now it has a nice range of speed… I have it set fairly subtle so it doesn’t get in the way of anything else.. Pretty good modulation pedal that has a good warble vibe kinda thing… Great for if you want...

YUP

must be a different board revision from build doc because current build doc shows diode in that location as well.... either way 82k was for R15 and 82ohm/ 82R was for R18.

everyone is likely different but I use a pcb holder so I can spin the board from from to back when needed. I solder everything one component at a time...lightly bend legs so they don't immediately fall out,, I hold with my finger and solder from the back of the board then clips the legs begore...

makes sense... I've just never physically measured to try and see...

My next dump question.... I have about 10-12 stomp switches that are 3pdt momentary... How do I know if they are normally open or normally closed? like what do I measure? I'm assuming I can likely use these up for rely bypass boards and just use one row of the lugs?

Thank You! I'm eyeballing a few pcbs.... I'll just order a couple from you this weekend with some relays and give them a try. I have a buddy that I built a Mahayana for him and it has mad switch pop... Was thinking of getting pedal back from him and installing a bypass relay and see if it helps...

I've never built a pedal using a relay board... If I just want to build a board out and use a relay bypass which board do I order for a standard off/on and what switch do I buy and where to get? Also does this help at all with pedal pop?

Clean AF... awesome

for future reference learn how to identify the inside of the LED.. if you look inside the led one side of the filaments looks like a flag and is bigger than the other side of the leg.... The side that is bigger and sort of looks like a triangle or flag shape is your cathode side... I've had leds...

Mark as solved if everything is working now

just confirmed your resistors are correct and the rest of the board... even took your substitutions into account... the 47k instead of 51k.. it's gotta be a wiring issue

it's very likely you have a short under the breakout board... I see this a lot with new builders trying to fill up the pads with solder.. it wicks under and creates a solder bridge under the board... I'm guilty of doing the same when I first started. I dont use breakout boards because of this...

post better pictures showing how your jacks are wired and also so we can trace the wiring from pcb to your footswitch breakout board..

for starters your LED wiring is backwards.. are you getting bypass signal?

literally killed every orchid we have bought...

Nicely done!

Finished up a dual build… Straightforward and everything biased out just fine.. Rangefinder with a Ruskie I was gifted from @jessenator and a Benson Preamp

I hear ya... obviously it's not a have to have but sure is nice to measure exactly what you have in your hand.. especially for germanium transistors

yeah a solid joint should wick to the other side and fill the pad.. could be one of your issues... plus the tranny pinout could be your major issue... all else looks pretty decent