ground loop stops when i hold both cables for the key/thru. is there supposed to be a ground between them? because it isn't shown on the wiring guide. very little signal is getting through. LED stays blue no matter what.
guitar into key > key out to dist pedal in > dist pedal out to gate input > gate output to amp
I haven't gotten beaten up by a build this hard in a long time. hoping someone spots my error. i would be zero percent surprised if i got the switching jacks wrong. i put a little heat shrink on the rest of the terminals of the switching jacks to avoid any potential shorting.
guitar into key > key out to dist pedal in > dist pedal out to gate input > gate output to amp
I haven't gotten beaten up by a build this hard in a long time. hoping someone spots my error. i would be zero percent surprised if i got the switching jacks wrong. i put a little heat shrink on the rest of the terminals of the switching jacks to avoid any potential shorting.
![IMG_5960.jpeg IMG_5960.jpeg](https://forum.pedalpcb.com/data/attachments/60/60544-9df368fa83ceba60322994e9a8128095.jpg)
![IMG_5957.jpeg IMG_5957.jpeg](https://forum.pedalpcb.com/data/attachments/60/60550-8f80f1c24940087dd3b863b380debaed.jpg)
![IMG_5956.jpeg IMG_5956.jpeg](https://forum.pedalpcb.com/data/attachments/60/60549-84f16938871d92093d5658e83e62194e.jpg)
![IMG_5959.jpeg IMG_5959.jpeg](https://forum.pedalpcb.com/data/attachments/60/60548-b3ce36bc27d97d503ddafb8c01d89c8a.jpg)
![IMG_5955.jpeg IMG_5955.jpeg](https://forum.pedalpcb.com/data/attachments/60/60547-a5f3be5098cfd6ef0f638fb540e17f5c.jpg)
![IMG_5961.jpeg IMG_5961.jpeg](https://forum.pedalpcb.com/data/attachments/60/60546-0cf89cb2f27ed306ab9f67e81462211f.jpg)
![IMG_5958.jpeg IMG_5958.jpeg](https://forum.pedalpcb.com/data/attachments/60/60545-6fc60023fa9d63374a60047166bcd639.jpg)