Byzantium Question # 2

[djmiyta]

I can't seem to find any 25k trimmers for this build ( so far).
Can I get away with using a 30 k trim pot?
It's the last part I need to complete this one> I wouldn't think there'd be a problem using a 30k since it's a higher rather than lower value. but, .....well that's why I'm here asking. Thank you for your time.

 

[Nostradoomus]

I'm honestly surprised you have a 30k trimmer over a 25k lol. It will be fine. Set all trimmers to noon, it's not a hard one to bias.

 

[djmiyta]

glad to hear that since I had no luck with both the pearl flanger AND the Boss bf-2 which I etched from other's layouts with no luck also the hollis flanger which does'nt sound like a flanger at all to my ears . Thanks for the answer I was hoping to hear and your time given to my question.

 

[Nostradoomus]

cool beans

 

[Erik S]

I'm working on an parts order for one of these too.

Looks like Tayda doesn't have 25k or 30k in 3362p, but Stompbox parts has 25k.

 

[falco_femoralis]

You can find 25k trimmers on Mouser. Their filter takes a minute to figure out but once you do it's not bad. Make sure to get the 3362P. The other letter suffixes have different lead positions

 

[owlexifry]

https://www.taydaelectronics.com/30k-ohm-trimpot-variable-resistor-6mm.html

i just used one of these 30K trimmers.
does the job.
pedal works.
not sure what the hang up on having to have 3362P is all about