Search results

Anyone know when the Build docs will be posted? I have completed all of the onboard components and have no idea how to wire it without some kind of diagram.

Thanks PJS, because I had snipped the ends after soldering , I was referring to the nodes inside of the LED

I have decided to order another board and will transfer most of the parts and replace the resistors and capacitors

I get no Voltage on the LED pins using Petal code or Terrarium code. All of the Petal examples work with the knobs functional but no LEDs or Footswitch functions. Checked my LED's and I'm pretty sure they are installed correctly with the smaller anode to (A) and the larger Kathode to (K). I...

I have received another Seed from Electro-Smith and still can not get any of the code for Terrarium to work. No sound at all. From the Daisy Web Programmer, I got a Daisy Petal MultiDelay or Tremolo to work but the LEDs and foot switches do nothing. I can engage or bypass the delay/tremolo by...

Thanks I was just looking into that

I can still program it with the Daisy web programmer but yeah it doesn't seem right that it gets hot

Two chips on the Seed when it is removed from the Terrarium. It also get hot when installed on the Terrarium as well.

I tried that and have the same results. With the Seed removed from the Terrarium, I have 2 of the chips on the seed getting extremely hot.

Built the Terrarium a while ago and was able to get a delay and a reverb to run on it however I can't seem to get the LEDs or foot switches to do anything. I suspect the Terrarium header may be wrong or missing in the code. I need any type of complete tested and working Terrarium code. I'm using...

My build with the pre soldered FV-1 works and I get the same feedback but only if the regen pot is past 12 0'clock. Cause?

I have programmed it as mentioned above but still no switches/leds are functional. I'm also getting no effect at all. I will keep at it and check the hardware for issues. Your help is greatly appreciated

I have tried several uploads using the Daisy Web Programmer and Arduino IDE. The sounds are really good but I still can't figure out how to get the foot switches and LEDs working. I can turn the effect on and off using toggle switch 3 like a momentary switch. the potentiometers seem to do what...

I am able to upload various effects from the Daisyduino library like reverb and pitch shift but I can't figure out how to enable the pots and switches on the Terrarium. I've tried adding the Terrarium.h file to my sketch and still nothing.

I'll look at that. I'm only familiar with arduino IDE at this point.

I have succesfully built and programmed the Terrarium with the Libraries/examples/Daisyduino/Seed/Autowah. The output emits a steady pulsing wah sound but the pedal controls do nothing and no LEDs Is there a build for Terrarium code that will utilize the pots/switches/LED's that I can load from...

Thanks, Ill try that.

Thank You for the soldering tips and possible problem areas. . I will review my method. I started using a different iron because the old one seemed too cold. I have 6 other pedals that work.

Pedal works both on and off but no chorus effect. LED lights up no effect dry signal. SOLUTION...I found that I had overlooked a build note about the MN3207 requiring a different Diode (1N4743) for protection. I swapped it with a cool audio V3207 and Voila!

Mine works with a very short fade in time(compared the the SG1 and Behringer clone) and it crackles out as the signal fades as well. Tried the trim pot at several positions with little change. Any suggestions?