Search results

Digikey is where I found them.

I have some of those incoming. I can send you a few when they get here.

Couple of those solder joints like the in jack to the board look suspect.

Ditto on the Ditto

Free shipping direct from their site: https://www.thepedalport.com/the-pedal-port

I try to set my temp to the task, soldering a board I'll run at 700, desoldering I generally drop down to 600, SMD maybe even a tad less.

When the solder feels sticky you need to clean your tip

I don't think I've ever worn a tip out, I have switched types a couple of times, pencil tip to chisel and back to pencil. On my old Weller 25 I did have to replace the collar that secures the tip once.

What size rolls of solder are you buying? I've been using the same 1 lb roll for at least 10 years and over a hundred pedals? I'm just about to start my second roll.

The masking service Tayda now offers cuts way down on paint inside the enclosure, you still have to clean out the drill holes though.

The Remington stuff isn't Pre-Bond, but the tubes and more wire description sounds pretty good, seems to state it's pre-bond

They aren't the same, the insulation on LMS wire is thicker, I use it on builds when Barry's wire slips through the hole insulation and all!

The pre-bond I get from LMS and GuitarPcb it's the case, rarely ever get a stray wire.

Post pictures of the board.

Oops, I didn't notice that letter difference, Stomp Box Parts has the correct ones I believe. https://stompboxparts.com/integrated-circuits-ics-/h11f1-optoisolator-ic/

That's the one you want.

Weller WE1010NA

On the next batch I'm moving the DC jack up (actually down) to closer to center on the E side, it's right up in those two pots where it is. Other than that, it was a breeze. Thanks again for the fantastic job on the UV design!

Built one of @jimilee's Dual Rats, first let me thank @southpaw-dd for taking my vague idea for the artwork and making it a reality. Not sure I care for the B taper pots especially on the Gains, they seem to instantly go from low to tear your head off, I'm building several so I may try going all...

I have a GuitarPcb board that has a double throw 4 pole switch, that you could make that easily. Be happy to send you one, I probably have the switch here too.