Search results

That one from Carl's looks like it uses the same L-pad from the article I posted. The DIY article also adds a selectable cap/treble bleed, which makes me wonder if Carl's uses a non-selectable one, or is it just the L-pad? Do you have a gut shot of it? For science.

One to look it is the Swart Night Light or Night Light Jr. Those seem to be designed specifically for small amps like Champs. Not sure about sub 4ohm speakers, but you could contact them. Also, you could try to build your own. Amp Mods (robrobinette.com) DIY Workshop: How to build...

Have you tried a treble booster?

FYI Anything I search for is giving me "A server error occurred. Please try again later."

If it's your first time and you're unsure what to do, start with a kit, specifically one that has good instructions. I started with some GGG kits. After a couple of those I had the confidence to source my own parts and use tagboards, etc. The Stewmac kits have pretty thorough instructions...

Man, pre-drilled service has saved me a lot of hassle and money. I hope this isn't permanent.

It's in the build doc.

Haven't had a problem with the ones at Tayda yet, but then again I've only had a few.

Maybe things just don't rock anymore?

Mecurial was my first thought. Maybe Tone Job as another option.

Something simple like a speaker cranker or other electra is a good candidate.

Is that running on 1.5 volts?

Did you reflow the middle pin on the A500K jack. That one looks suspect, but could just be the picture. What's up with the clipping switch. Mounted on the opposite side of the board?

Lightspeed is great but I don't think it fits what they're asking for. I was thinking crunchbox deluxe, but that's more gain they want. I haven't tried an OD-3 but agree from the descriptions I've heard about it, it would likely make a good match.

2n3904 has an odd pinout? The ones I've used had the same pinout of most BJTs (with the exception of bc549s--now those have the odd pinouts).

They'll give anyone a well known member tag here. <- ???

Don't forget this one: Basic Buffers (muzique.com)

I've build the BSIAB2 which is a very similar circuit, but used 2n5457s. If you have some to try, pop 'em in and see if they can be biased.

For this they're the same. The Vcc- in most pedal circuits is ground. I don't think those ICs would be the issue.

Desoldering videos always make it look easier than it is when I try it.