Search results

Had a hankering to finish one up tonight… Sounds pretty good… Light overdrive at its finest

Seems like some thought would definetly need to be put into how the lfo timing between the two react for sure....

then your spot on pretty much!

generally if your using a cheap tester you will have some of those show up with large HFE like that 187..... it's likely a really leaky 80-90 hfe

yall know i'm a big fan of the zero resistor

does the pot have a cover on the back?

I’ve put this one together from start to finish this weekend… I’ve built a couple in the past that just didn’t pan out… This one is fine if you stack both sides reasonably.. if you crank both sides it’s squeals and oscillates… tried switching out the charge pumps and three different types of...

Was originally intending this enclosure to be for a Nobleman but after building It ended up being g a dud.. I signal traced to a electrolytic capacitor I trimmed too close to the board and chucked the build in the maybe later bin… Ended up building g out this hatchet and it the first time I...

desoldering pots is pretty tough for a first timer... you really need a good solder sucker,,, the "engineering" type... I recommend just cutting the pins and pulling one pin at a time and either replacing the pot with new or potentially offboard connect them with individual wires if you really...

pinout seems oriented correctly

I generally socket my trannies so I can pull them if needed to swap a different set for a ge fuzz build... but you absolutely could build a deciated pedal setup just for checking your trannies to see how they sound.. something simple like a sunflower fuzz where you'll be able to dial in bias and...

Like Eric suggested that daughterboard is not compatible with the kliche.. it has it's own daughterboard..... there is a way to wire it truebypass without the daughterboard on the build doc

My last name is Welch... like" Welch's Grapejuice... My buddies in highschool and college always called me grape juice. so It kinda stuck on me i would say... Doesn't have to make sense. Just love me for what I am.

you cant measure resistors in circuit... they wont give readings correctly....

good catch!

See what happens when I’m home alone all weekend….. A big nasty fuzz… This one doesn’t sound as good as my last two foundries but it’s definitely unique…. Any amount of the stab knob other than full clockwise brings in crazy oscillating .. Not necessarily a bad thing…The fuzz is thick but almost...

electrical tape is not a good idea... the leads can just poke through and short..... hook up power to pcb outside the enclosure.. bend the treble pot off the board and test for signal with all controls

wait... what's with the wires coming off the dual gang? is that a single gang and you have wires doubled up? and do you have back of treble pot insulated with a dust cover?

i'm not familiar with those particular jacks... so i'm no help there... I do see some of your soldering isn't wicking to both sides... you could have a cold joint.... unbox it and go ahead and touch up your joints.... and does your led work?

I prefer one color for wiring because of aesthetics… I wire the entire PCB after populated with all wires a bit longer than needed before putting in enclosure…I trim and solder each wire to the switch… then I trim and wire dc jack… slip in the jacks and trim/wire the grounds at top of pcb… go...