Search results

I think I want to hire you to do all of my enclosures. Enclosures are the worst part for me. I love everything else with the process. An enclosure will hold me up on a build for months sometimes because of my OCD. I can’t start a build until the enclosure is ready. I always pop in and check...

Hey gang, I’m in the process of building the Emu. I’ve done my homework and I understand that the slide switches need to be elevated a bit off of their pcb’s as to not conduct between the metal body and the elevating pins. Back to the metal body now. I’ve opted to not use the face plate because...

Thanks for the info. I’m sure I’ll figure it out once I start actually test fitting things. Just doing a studying ahead of time. Thanks again

Getting ready to start this one soon. From what I can tell so far, the header pins attach the break out boards to the main PCB then the switch’s mount to the break out board. You say not to mount switches all the way seated into the break out. How far should I elevate them? Just so there’s a...

This is pretty cool. Thanks

If you’ve got a decent amount of solid builds under your belt you should be fine, but I can’t stress enough,,,, do not stray from the directions one single bit and take the time to double check/test fit things. It’s a tight squeeze in a 125b. Only and expert should think about changing anything...

I’ve done it and to echo what’s already been said, it looks more difficult than it really is. Following the directions to a T, it went together without any hiccups. Thankfully it fired right up and there was no troubleshooting needed. There’s a shit ton of parts. Not a cheap pedal to make.

Awesome thank you very much. Now I just have to figure out how I’m breadboarding this wrong and still coming up with 9v at vref. Baby steps. Thanks again

Still trying to expand on my schematic reading/breadboarding skills. Can somebody tell me if this is correct. The 2 circled 10k resistors are acting like a voltage divider in this 9v power supply circuit so the voltage at VREF should be approx 4.5 volts. If I’m not reading this correctly can...

Everything I’ve received from them has been top notch. They’re getting closer and closer to being my one stop shop

I use envirotex epoxy. It’s pretty bullet proof once you get past the drilling. It’s definitely not for everyone. There’s a serious learning curve when it comes to drilling out your holes. It takes the patience of a saint and quite a few fails but once you’ve got it it becomes surprisingly easy.

Nice and clean

Ok thank you so much. I was kind of thinking that was what it meant but wanted some reassurance.

I’m expanding on my schematic/breadboarding skills and I’ve been moving right along. I’m a little confused about this symbol I encountered today for this spdt switch. Could somebody help me identify what’s going on here with lug #1. I see that #2 goes to ground and #3 comes from the cap, I just...

Dig the artwork

I use the standard ones. Started off using them then tried without now back to em. I think it looks cleaner.

Could use more pics showing dc, in/out jack connections and solder side of board

Sweet

Ok cool. This link worked. Thank you