Search results

Also, I'm a card carrying member of the Brassmaster Fanboi Club. It's a lot of fun. Preamp and/or compressor maybe. Where's @Feral Feline ?

Compressor, fuzz, chorus/ slower flanger/phaser It's kinda genre dependant but I think compressor, as unsexy as it is, is pretty universal. Any idea of what genres they gravitate towards? Another unsexy rec, EQ. Maybe the drebbel?

Govdeals.com

Hard to tell but IC1 legs look off. Also, make sure you didn't mix up nF and uF with all those MLCCs

I use my grandfather's drafting chair that he had at his workbench Not dissimilar to this one https://ebay.us/m/fDmVSJ Edit to add. It's likely from to 60a or 70s and built like a tank. The footring is nice as I can go from sitting to an elevated standing position on it to reach to to shelf of...

Punch a bunch into consecutive rows of the breadboard Then move dupont jumpers to measure each one. That will give them enough time. It all depends on how you handle them and how long. Also, don't measure them in a cold basement/hot shed.

I share this hot take. As long as you straighten the legs of the IC enough, leaf sockets are quite easy to use. I'm more inclined to just solder ics at this point

Just get a drill press on temu. It will show up 1/4 sized.

Here I was thinking it was the new immigration policy.

This is likely a combination of low harmonics creating "undertones". It happens on most plucked or hammered stringed instruments, particularly with intervals. It's possible that it's being exaggerated by the compressor, bringing the low level signal higher, high level lower. It is from...

Few alternate 1, replace the gain pot with a linear pot 2. Replace R10 with a 500k and switch another 500k in parallel. A "MORE" switch. It may be worth upping the wattage rating to the next class of the non-swo5ched resistor. 3. Mess with the jfet input buffer?

This just in

Filtering at the opamp is generally considered a best practice. But, it's a pedal not a medical device/aviation equipment etc. Added filtering at the opamp would be good in circuits with say clock signals. The considerations made in a TS clone vs a BBD delay can/should be different. A sloppy...

Varna Snarka!

Friend in Jesus Fuzz

https://www.alphapotentiometers.net/Trimmers/html/chip_trim_pot_4.html These have a 8.8mm span between leg 1 and 3. 16mm pots are 10mm I believe, so a slight bit of bending may be needed. Could possibly bend the legs and mount flush with the board These may also work...

For the next Surprise Me

Nope. I still gotta build that BIG HICK pedal

Mostly harmless, but careful with bbd inputs. Don't want them too hot.

Ignore the smd footprint on the PCB. It has no correlation when using an adapter. Just put the 3 legs in the 3 holes. Use right angle headers to tighter clearances.