Search results

?Stoked. I subscribed to your YouTube channel by the way. Good stuff!

I just thought of this today. Thought I'd share. Am I overdoing it? Probably. 3M double sided tape on the BOM

If you have any DPDT stomp switches you could save that for another project and do what I did, like this

I'm prepping for my next build, the Fuchsia Fuzz, and was just wondering if I did this right as this was the first SMD component I soldered and I used an iron since I don't have a hot air device. Checking the pinout of the MMBF4393, I used the j201 side of the SOT23 Adapter. Is this correct...

Actually, on further inspection, you should definitely reflow some, if not all, your pot legs. They look a bit cold. My iron is set to around 750°F and I generally spend roughly 2 seconds on on each lug, sometimes more if I'm coming in at a weird angle. In practice, I always do one lug of one...

Fwiw, our technique looks clean and those are clear photos, so thanks. The post I made for the workflow tips was that same pedal. Regarding the possible short here's a tip that that I do on all builds. Specifically figure 18 and 22 from here...

I had a lot of practice with P-touch around age 13 onward.

Thanks! That font was my attempt at finding something that looked like the 70s Univox SUPER-FUZZ typeface. It's pretty close! The font is called "Viktor"

Hot off the bench. This one is a beast! I am most definitely going to keep it as it's a new favorite. I never got to play an original FZ-2 but now won't need to! It is heavvvy! The tone sweep is particularly useful on this one. There is no bad setting on any end of it's range. It also super low...

Thanks folks! Pretty much. Same size but they're called "Mission Control" from Love My Switches.

That's really cool! I love that enclosure. And that circuit. I'm interested! What would you recommend for drilling one of those for next time?

This is the pedal I built last year from this post. I always had this design in mind but wasn't sure how I was going to execute it with my dinky old P-Touch. The inspiration for this design comes from the demonic house cat from a bonkers 70's Japanese psychedelic horror film called House, or...

Straightforward build with no issues. P-Touch printed labels. Quick n ez!

Truly inspiring, Chuck! You are a wizard.

Working my way through roughly 40 PCB's from last year. This is the 4th Unison I've made with the intent to keep but this time I mean it, I swear. Built this with the stereo Mod so I can run it to two amps. I used the P-Touch for labels and just noticed I put an extra "-tune" on the top right...

Here's a fantastic mod to allow the Unison Double Tracker's output to split into two channels, one wet, one dry. You can sculpt adjustable space, time, and dimension between two amps, i.e. Strymon Deco, Keeley 30ms, etc... Or how about panning ping-pong slap back? Or detuned in one amp, clean in...

OK, that's what I needed to know, thanks! Oh yeah, I forgot about those DC breakout boards! I have a few of them floating around somewhere. Man, I can't believe I forgot this. ha.

It's been awhile since doing these on the reg so I'm a bit rusty. Here I have my main board and relay bypass module soldered together via pin header. I added red and green circles in reference to the question below. My question is, when connecting the pcb with attached relay board to...

Hey Barry! Yeah I kinda went AWOL there. End of 2019 I was bonkers full throttle with work and just had no free time to do side hustles and me-stuff. Then 2020 happened, lost my job among other setbacks, so I squirmed back up into my shell and hibernated. Slowly emerging and I gotta say, it...