Search results

How about the TweakIt? It uses all three pins and can be externally accessible by side-mounting it in the enclosure if you'd like. https://www.pedalpcb.com/product/6-9-3/ (Or you could just kludge a 9mm or 16mm pot in there, I've mounted full size toggle switches internally before)

Well on the bright side, your soldering looks much better than the other one. :ROFLMAO:

Man I repaired one of those "indoor rollercoaster simulator" rides one time, the PCB in the control module had been shattered somehow and pieced back together with JB Weld.... This thing took people up in the air and swung them around and stuff.... No thanks. EDIT: This thing... (older...

You'll have to goop it yourself. I also added polarity protection and a filter cap but you're welcome to omit them both and live dangerously. :ROFLMAO:

Does the LED light up? Do you have a DMM to take some voltage measurements?

No, that's not right. Pull the ICs out of the sockets and measure again on the empty sockets.

Tayda has through-hole 2N5457's? :unsure: Do you have another set of opamps you could try, by any chance? I'm not familiar with the ones made by ST (mine are all TI) but a TL072 with a notch is usually a red flag.

Don't worry, I saved it for you.

Had.

Seriously.... if you're going to goop a pedal, please, use proper polarity protection. Anything less is just rude.

This guy too, ironically. (Sorry @swelchy, this should all be over soon)

I've decided to phase out PCBs and start offering pre-cut veroboard instead. :ROFLMAO: It was a "quick and easy" trace verification, and I figured this way I could go ahead and put the original back together. (I usually leave them disassembled until time to verify the PCB) My work area...

Well, they're obviously shipping to someone.... I'm not sure how all of this stuff works. The concern seemed to be that I might break it and demand a refund or repair. Apparently someone else had done that in the past, made a mess of it, and since it's Reverb I suppose they usually side with...

That reminds me, I should probably wash my hands, it's been like 10 minutes.

Monks gone?

The gain will be higher/lower respectively.... I can't say if it would or wouldn't be audible, but probably not enough for concern considering tolerance.

Correction to what I said yesterday... I do not believe the transistors were sanded after all. I think maybe the primer etched the face of the transistor slightly and made the part number harder to see. I'm not huge on candy, I have my moments, but the truth is I kinda just set it up there...

Posting these for @huntest (You have to reply here, not to the emails from the forum) I assume your bottom row of pots has dust covers like the top? Have you tried adjusting the trim pot? I'm suspicious of your TL072s, but I'm not sure I've ever bought ST brand before so they might be...

Known name? Yes. My name? No. I don't think they're shipping until April/May anyway. Funny story, since you brought it up.... A couple years ago I bought a PastFX pedal on Reverb, from PastFX. Immediately got a private message "Are you Robert from PedalPCB?" ... (from Verle? I...