Search results

Have you double checked your tants for polarity? Sometimes the + side marking can lead to installing backwards.

Trim pot. Then adjust to your preference. Or then measure the setting on the trimmer and install that resistor.

You can test the ic socket for a bridge or if it is making contact with the PCB by taking out the ic and using your meter to see if the socket is going to the pad underneath and/or the trace next pad on top of the PCB. That would rule that out for you if you are concerned with a short.

Have you tried swapping around the Bbd yet? Or measured the empty sockets before installing them?

Did you get the echo ic from him?

I was saying a good first step would be swapping the ICs between the two pedals to confirm they both work. There are plenty of fakes for the BBD ics and some could just be dead on arrival. Are you saying it is the same physical Ic or you got them from the same place?

If you have a working one you can compare the volts. Have you swapped the BBD ic? The text font looks a little different.

Glass bead kit, or some glass rods might be fun for you.

Is the diode in the wrong direction bottom right?

Any tips on components? Or anything odd about the build? This pedal is up next for me.

https://www.taydaelectronics.com/15-uf-16v-radial-tantalum-capacitor.html

Where is a good place to get transformers now? Triad looks about done, and what I do see, the pricing has gone up a lot since I was working on amps.

Just a couple things from the images. I don't see much solider in the very top black diode. I see it in the bottom pic though. Might reflow? Second, is the switch physically shorting anything? It looks low in the picture but that just could be the angle of the picture?

Which box did you use? Model/size

Are you in LA by chance?

Ditto, “replaced the red led's with 2u2 MLCC's”. What difference does this make?

Do you have any pictures of of the inside or the Accutronics Belton BTDR-3H ? Do you know the difference between the 2 and this 3 model?

Hi, the schematic is with the build instructions. But the leds goes to the switch. Power on the other ends

I have not had any issues with these so far. But I don’t sell pedals. https://www.taydaelectronics.com/hardware/dc-power/dc-power-jack-2-1mm-round-type-panel-mount-1.html

Thanks for the reply. I added a bit of the ic foam when I put it together also.