Search results

Newborn fawn behind the house. As much as I despise the species, generally destructive and their only natural predator is stupidity, they are cute when they're young. Mama is snorting back in the woods. Guessing she'll be back tonight. Also guessing she's responsible for clearing out my...

No sockets. I like your style.

Are you using a test tone? With this being a filter network, not all frequencies will pass through C12 anyway. You could pull c12 and the circuit should still pass audio.

I doubt many here fly with guitars but this seems like a decent discount https://www.musiciansfriend.com/stupid

It's only a matter of time before Robert's foundation IS pedals. Probably cheaper than concrete in today's economy.

Apparently 8BombCustom was heavily involved in this. Whoever Dr Nitro is.

Have you ever removed AI generated goop?

Where was the leakage at on the board? Between U1 and the C1M? Seeing some vias that look like they're missing plating.

Have a short or a bad switch. Did you use pot condoms or just shive a wish between the pot and PCB?

Try again tomorrow.

It's likely that the reverse bias of the clipping diode is causing an asymmetrical clipping of the audio and decreasing it's overall level. Or perhaps this is just how the original circuit was designed. I highly doubt C22 is at fault.

Anything over the starting bid. Idk. Value is in the eye of the bidder I guess. That seller is rather proud of their wares.

Worth it if the price doesn't go too high https://ebay.io/m/g8q1DL

Beautiful execution as always. Isn't the 2 knob Satisfaction just a ShoBud bosstone?

Offensive and immature content:

Beautiful build and execution, as always! Glad some things from the pif are being put to use. Is sleeve ground fully isolated from the enclosure and power ground in this scenario(relying on the next device in chain for ground reference)? What about enclosure grounding?

Just build it stock and try any of them in Q2 position. I wouldn't bother with Ge in Q1. You'll get better performance and likely better noise using Si there. There may not be enough gain from your germs in Q1 to properly pumble Q2. Check some other build reports and thread on this one as to...

Jack/cable/solder joint/grounded signal issue . Plug a cable in both ends and put it in bypass. Test resistance from tip to tip of each cable. Should be <5 ohms or so, deducting your lead resistance from that measurement. I would also check input tip to ground and output tip to ground. Those...

To be fair...