Search results

Hey guys, I finally have the time to play around with DipTrace. I'm starting by trying to draw the schematic for a TS-808 to get familiar with the program. I added the Rullywow library but I'm getting stuck because I can't find the VCC and VREF "components" What is the best way to set those up?

Well this was a straight forward and enjoyable build I did manage to solder a tube socket to the wrong side of the board. I was able to remove the tube socket so fortunately I didn't have to replace that. I ordered the replacement board, and being a good guy @vigilante398 gave me a few extra...

I was able to get the socket off, but pulled the copper tubes in the holes out by accident. Just ordered a replacement board.

Okay, thanks. I'll attempt to desolder it. But I may need to order a new daughter board.

Like an idiot I soldered the tube socket on the wrong side of the daughter board. Will it work if I just place the daughter boards on the opposite sides?

I see, in bypass the mute line overkills the signal 😜

Thank you. I guess I'm confused, I understand what the buffer does but what is the mute pad for?

Thanks, I should have specified, I'm using a PPCB 3PDT breakout board which has 6 connects.

Should I connect the mute and buffer if I'm just using a 3PDT?

Awesome, I'll play around with the LED placement. Thanks

Like this?

I'm getting ready to place the LDR/LED in my General Tso build and want to make sure I do it correctly. My plan is to the LED touching the LDR, and then cover it a tube of shrink wrap like this: Should I heat the shrink wrap tight, or just tight enough to block the light out?

Thanks that's good to know. I think The Diplomat is getting added to the build list!

This was a surprisingly straight forward build, with the very detailed build instructions. This is my first time working with tubes and I was nervous at the prospect of debugging a high voltage pedal, but fortunately everything worked the first time around, and didn't require debugging. And it...

It looks like the potentiometer leg goes to ground as does the pictured resistor, r19, so I'm guess their should be continuity between them. Can anyone confirm for me?

I haven't finished building this yet but the two pictured pad and showing connectivity on my DMM. Is this a problem and if so how can I fix it. The pads are really close but there is a tiny gap in the solder between the.

OMG, yes the jacks were wired incorrectly. I fixed, and the pedal works beautifully. The IC is fine. Thanks all for catching my bonehead mistake!

No I didn't replace it. Sound like it may be fried, is there a way I can test with a DMM?

Well no more smoke, but I'm generating a tone, where the frequency changes when I play with any of the pots. FYI I did sub JRC4580Ds for JRC4558Ds.

Only weed