Search results

It has some good tones in it but I don't like dialing in it's eq at all. I did swap the 9.6nf cap for a 10nf because I didn't have it but that shouldn't be the reason.

Nice little thing that maxes into fuzz. Just used a b25k instead of b22k pot. More eq would be nice to mod into this.

Swapped 51e's for 4148's. Didn't get too specific with the special resistors. Not much to say except it sounds great! Stompbox parts cosmic lilac

I think I see the hype! It's pulling out country riffs I didn't know I had in me. Sounds great. Stompbox Parts Brunken Blue.

This thing is way better than it has any right to be with a name like that. Or just the right amount.. I've only tried it a little bit but it sounds sick. I used a tl072, I put it in right after the pic. This enclosure from stompbox parts really turned out nice. Sorry this one's a little messy...

Hell yeah, and they are the dark red knobs from Love My Switches and Tayda's matte army green for the record.

Made a couple of these for me and a friend. Used some ~80 hfe MP38A's from a batch I got from Oleg (SOVCOM) and changed the 120k resistor to a 100k to assist in the swap. I like it biased to about 4.6v for more of a variety in it's response like going from the bridge to neck or when using the...

Made two of these actually, one for a friend and one for myself. It's a cool little nasty thing and we both love it. Not impressed by these enclosures from Love My Switches. The paint volcanoing up and chipping away when I use a center punch is not ideal. Tayda ones don't do that. But hey I made...

Where'd you get the preamp PCB? I'm looking for one but effect layouts doesn't sell the paladin anymore and hasn't messaged me back.

Honestly I'd start with adding more solder to basically everything and then go from there.

I definitely agree that you should breadboard, especially since it's a simple circuit/not a lot of parts. For the fortin fuzz (another silicon fuzz face style pedal), it uses bc550c's and has a 120k resistor going across the two transistors at the bottom. To use mp38as and get a decent amount of...

Thank you I did do the driver reset thing just in case. Followed the whole getting started page and couldn't get it to load at first. I ended up having to use the daisy flash loader on the website instead of trying to build and load from VS code. Not sure why, but it worked at least so the new...

Ooh I didn't even think about team bezel or no bezel... I used to always use a bezel. But recently I've been really digging the look of no bezel! And only use a bezel if I fuck up the drilling. I even drill the final step from the inside to help avoid any chip out. Boss didn't use a bezel. Also...

I have too. You said that right after perhaps the longest and most detailed helpful comment I've seen someone take the time to write up on here though.

Are the cheap lumberg style ones from tayda really that bad? I haven't had an issue with my cables and if anything tight jacks should mean a solid connection right?...

Huge globs of solder on both sides of the PCB near the led shorting out stuff. Also if any of the pins started moving while soldering the foot switch then you need a new foot switch. Once those pins become out of place they aren't making a good consistent connection that you can trust and even...

It finally arrived and upon visual inspection looks great. Computer recognizes, now just trying to load the blink program to no avail. But that's probably mine or my computer's fault.

I would but they are so ugly ngl

Fair enough thanks! I'm not on that forum so I suppose I might as well ask through the effectlayouts instagram.

I'd build a jc 120 preamp if I could find a board. Effect layouts used to have the "paladin". The build docs show up and stuff but no option to buy the board.