Search results

Such a beauty !

That's the plan, just not a priority right now. I've slowed a lot. I have 4 boards on the bench with resistors waiting to be soldered. It's just been a busy summer! I already have a mapping of what voltages to expect at every point, just need to take the time to do this. I'll sure let you all...

Bad news is something is wrong with this build. At first I said it was really not powerful for the supposed wattage compared to my wife ac4 playing at 1/4W... but now it's silent. I can get a signal if I use a preamp pedal in the fx return jack but thats about it. I need to take some voltage...

The transformer sits on top of the enclosure. There is only two holes with rubber grommets for the wires to go in the enclosure and four small holes to screw it on. Yae, my step drill was enough fot the valves. I think that enclosure is aluminum, so drilling was easy, for the plug i drilled a...

Last week I was in Tuscany, such beautiful landscapes. We had a great time.

As long as it's on the good side of the pcb, orientation is not a problem.

Just received one drilled at a 21 mm spacing ... it's still not perfect, they are a bit too close now. Maybe a 21.5mm spacing would place them in the right spot. Just letting you know if you did not made an order yet.

I had that board populated and laying around on my bench for a few months, did not seem to find the time to build lately. Last winter, I won a Stompbox Parts gift card generously. I picked a pink 1590B enclosure and thought it would be perfect for a pink alpaca. The build went really well...

I guess that could be it, mine has a really matte finish.

That must be the shortest report ! Is that tayda's candy pink ?

Sometime a silicon substitute could do the trick for some time until you are ready to source the ge one.

I have a 24V 6A power brick and am tempted to build a bigger power supply based on the old Anasounds files... https://anasounds.com/produit/fx-power-source-8x-9v-2x-12v-and-2x-18v-full-kit/

And that's fitted with the following, as suggested by M. PedalPCB himself, I may have added a washer so it's snug. 5mm Male standoff paired with a 20mm Female standoff

Looking back at it with fresh eyes this morning... 1mm too far apart. That one was drilled at 22mm distance and I already adjusted my drill template to 21mm but have not tested it yet... holes could be a little smaller if I was certain about the placement. Anyway, here it is ...

I had one but the spacing was not perfect... like maybe missing 1mm between holes. It's working though.

What's the meter your are using, I ordered a board a few weeks ago but was not fast enough to get the full kit. I figured with the drill template I'll be able to make it work, but will it fit without the faceplate ?

Well, I've rewired it using shielded wires and it made no noticeable difference from my initial wiring. I put a brand new IC from mouser and it made it a little better. I'll call it quits, that must be how the circuit is supposed to sound. Maybe someday I'll recheck the pot wiring, but I doubt...

Same, but there something i like in that last one.

I had found some on amazon that were 12in each. I found them a little brittle but to make connectors that could work. There was no choice of colors.

@djmisaid this : It's exactly the sound the pedal make in clean mode. It makes what it supposed to, plus that sound. It's there in disto mode, but les noticeable.