Search results

You need a design called the Plastics and Glues on the Hooves

According to the designer this is supposed to be a sludge machine, sorta emulating a Rat into a Sunn but it's really just a generally great sounding dirt box. I'm not a sludge connoisseur, though 🤷🏻 Not a huge gain range, going from crunch to CRUNCH, but it's got some decent versatility to it...

Simple. Nasty. Gated. Heavy. Not a whole lot to say about this circuit, other than it does the thing and it does it well. It has a very heavy 90s alt rock kinda feel to me when the the choke is dialed down. Tales to palm muting well, but isn't effected too much by other pick dynamics. Its a ton...

Yeah, I've got the Opus setup for a Twin voiced amp into a Jensen 212 IR. I think that one is setup for a SM57 on the dust cover and an 87 on the middle of the cone, both about 12" back 60-64 is about as big as I go before I lose too much pick attack, but it does do wonderful things to most...

Yeah, I was kinda surprised comparing it to your demos, but I'm absolutely enamored with the sounds I'm getting from it. That it pairs so well with my Rats is 🤌🏻🤌🏻 But, it's just a standard passive Duncan Broadcaster pickup

Guitar is - 30" scale, tuned to drop A with 12-60s. This was plugged straight into the Rat2, Peacock and Opus into my audio interface No intentional mods except I only have 2N7000 on hand. You seriously did a damned good job on this. I'm particularly fond of the Percolator side- I love that...

Sorry it took so long to get this report up, been busy closing up a Rite Aid 🤣 Sorta a modernized Fuzz Face running parallel with a Harmonic Percolator, this guy brings the ruckus. I haven't been this excited after building a dirt box in quite a while, and this one's earned a spot on my...

They were $18 each when I bought mine

These are the ones I've been using Quality is high, the aluminum is thicker and harder than Hammond boxes. Dimensions are 6-5/8 x 5". Depth at rear is 2"

This is what's in my big triple Rat. Works wonderfully except I do get a pop when switching channels I don't have any issues with the 4PDT loop (no master bypass) selector, though

I haven't seen a board, but they're easy enough to wire up I like this one from @Feral Feline's Switch-craft thread

The filters sounded great, and the range was wide, but I never cared for the expression implementation

The difference is that the pot will also adjust the gain of the cutoff It'll definitely work, but won't behave exactly like the rotary

Guitar is a Warmoth/ Kunkle baritone with an SD broadcaster pickup into a Two Notes Opus on Foundry setting with Jensen 212 ir Built to Turbo Rat spec with a few tweaks - R7 reduced to 470r to slightly increase and tighten up the low end pole R9 increased to 2.2k so it doesn't get as shrill as...

Also, make sure you used a C1M for the decay. If I recall, the first version of the board has the decay marked as B100k If you're wanting longer decay times, feel free to increase the value of C8

Basically- this has the tone bypass instead the Hi/Lo of the original

I've grown fond of placing the toggle above the pots like so - Keeps it a bit more protected from stray boot stomps It does require use of sub-mini toggles, though

Thank ya kindly

Any chance we could get a schematic for the Signal Buffer / Inverter?

18vAC to a collosalus