Search results

Any of you smart people know if this C50K tone pot could be replaced with a 10K pot in this circuit and still keep the same sweep, by adjusting the component values around it? Or would it not work or be more work than it's worth? The reason is I'd like to add in a 10K expression pedal input so...

Hi all! First off, this is my personal build and not a PPCB project. If that is not allowed here let me know! I am really stumped on this one. I designed my own layout and circuit board and it has been assembled with SMD components by JLC so I am confident that the component values are correct...

Howdy. I’m getting no effected signal on this Byrdhouse/Janglebox build. Bypass works, LED works. I used a CA3080EZ in place of the NTE996. I don’t have any others on hand to swap in to see if it’s IC. Audio probed I have guitar signal at pin 2 and 3 input. No signal at pins 5 and 6 output...

Are these interchangeable in this Klon clone? I'm building the Kliche mini and it calls for the TC1044SPCA but I only have access to a MAX1044CPA. Just wanted to make sure it will work before using it. thanks

Building the closed circuit limiter/booster. I don't have any BAT42 diodes. I have BAT41s and 1N34s on hand. Does anyone smarter than me know if they would be a suitable replacement in this circuit, or any other diodes? Or should I try to hunt down some BAT42s if they are key to the...

I screwed up and soldered the first dpdt switch of the three effects (centre chorus on/off switch) on the wrong side of the board. I was able to remove it and reinstall but pulled off a few pads in the process. So I’m going to need to bridge some connections from components before, to and after...

Howdy, I ordered the Pitch Witch and the Pendulum Tremolo PCBs. The Pendulum calls for GL5516 LDRs and the Pitch Witch for a “1M LDR”. I’m new to LDRs, how do they differ and labelled? This is what my local shop carries for LDRs. Will any of them work for these two pedals? They mark them as a...

When engaged the volume is really quiet. Bypass doesn’t seem to work at all. Did I miss anything obvious? I used 2n5088 transistors instead of BC109 as I read they were a modern equivalent. Would that cause a problem or did I put them in backwards? The only other difference from the build...

This is my second pedalpcb build and second that doesn’t work after completion. Very frustrating :/ Bypass works. LED works when engaged. Zero sound coming through. The only thing I did differently from the spec sheet is use 12K resistors instead of 10K because I didn’t have any on hand. But...

Howdy, this is my first pedalpcb build and one of my first pedal builds in general. I just finished putting together the Pauper (Prince of Tone) and it doesn’t work. Bypass works. When engaged it makes a loud screech that changes frequency when adjusting the gain knob. The LED does not turn on...