Search results

Hey all -- I'm about done with my Skeptical Boost but I noticed that the 9V input spots on the PCB are marked "~ ~" instead of the usual "+ -" I'm assuming it should be + on left, - on right (looking at the printed side) like usual. Is that right?

[Apologies if this should go in the Spin FV dev forum] Just finished building a Binaura. Using an EEPROM from MAS Effects (per this post). I'm getting sound output, but vanilla -- no effects at all. Tracing the signal, it dies at the Spin-FV chip. Signal's going in but it's not coming out...

Maddening problem with my Flock Harmonizing Fuzz. Thanks to this thread, I've tried re-flowing the rotary switch pins (and pretty much everything else), swapped out ICs and such. Still, no joy! The problems: Persistent feedback squeal where the pitch changes based on the "track" knob. Nothing...

Preferences on Emu vs. Runoffgroove vs. UniCab? Just want to get a good signal from my pedalboard/amp/line-out combo into Logic without having to load sims in the software. Right now the signal is very low and tinny. [Current setup: vintage Fender amp with a Bray Line-out box into a...

I'm sure this pertains to any kind of pedal, but I'm experiencing this with the Low Tide Modulator: When tracing the signal, I noticed that I'm only getting 1.2V at the 9V jack. (If I plug my power supply in an un-wired jack I'm getting the full 9V) Does that mean there's a short somewhere...

Hi all, first thread post! I installed a Spin FV-1 onto my Leprechaun board, and I think I got the surface mounting done right. Is there a good way to test it before I populate the rest of the board? I'd hate to think I fried the chip, only to populate the board, and have to start again from...