Search results

I'd like to get a faux leslie speed out of the photon vibe...it doesn't go quite fast enough. Can anyone suggest what to tweak? Those 4.7k's that feed the dual gang C100k pot? Thank you

I love this board, have built a bunch. Would love to brighten it just a bit...slightly to dark for me. Was looking at the Schematic and the network around the tone knob. Any suggestions for values? thank you :D

'Nuther fine job by PedalPCB. Love this place.

Nice JFET JCM thingy. Need to try with my Agile Paul instead of low power tele pickups....

Just got the speaker cab in yesterday to complete this (still gonna change the cathode to fixed bias) project which sounds great. Nothing like fat octal preamp tubes. Never been a fan of the Fender tonestack so went with Baxindall and I'm digging that. Kinda Fender meets Ampeg thing. Bit messy...

I'm not a compressor guy, but this pedal is very very nice sounding. I did all the mods except the treble boost as it gives a bit of sparkle without it. A tasty amount. The only way I'd know if it needed that would be to gig with it but this is going to Montana...Board by JMK

Sounds fantastic. One problem, I'm only getting 2 modes. As I typed this, I realize why. I wrongly ordered a 1P8T switch, and needed a 2P4T switch. Dammit. Be a bitch trying to get that switch out...Other than that.....

This is another impressive circuit by EQD. A small stone on steroids. Thumbs up.

Sounds...good. Bit dark.

It was Joel's (see the delay) Birthday...

Forgot I had this laying around, not working (like for a year, not my neatest work). Came back to it, found my problem, did some repair on the graphic and BAM. This is my favorite vibe here so far. Quickie video

Thanks for the wiring help, Mike. Being able to output left and right, splitting the units, but controlling the rate using the sweep switch is fantastic.

My pulse and filter aren't working....don't know why yet.

I know I'm missing something for the 2/inputs 2/output wiriing. Instructions say Tip of the Out on Phasor B to the Ring of the In on Phasor A, correct? When I do that, I'm never able to access both phasors with one input. I've been wiring tip to tip to make it work with input B to output A as in...

I've checked every value, my soldering is solid, I've even swapped the TL072 and the HT8950. Is it possible the eprom isn't functioning properly? Would it be possible to send you this one back for a replacement, if you think that's the problem? Or I could just buy one...also when I pull down the...

No problems, sounds great, Thanks once again PedalPCB!!! I LOVE THIS PLACE.

Happens in bypass and coincides with the rate knob. Could I ground it out with the stompswitch from a lug on the rate pot? Thanks

Came out great.

Phasor A's LFO isn't pulsing, bulb is on. Interestingly enough, the charge pump is heating up as if it were in backwards, or the position of Electro's and or Diodes were wrong, but none of that is true. Looking for solder bridge but there is none. Please help? Thanks Geek