Search results

Love the design and large pot labels. Looks pro

yes, I only recently began using the step bit, I used to bust my knuckles. Now I use a jig, an automatic center punch, a pilot hole, and then I use a drill bit for the LED hole and the 9/16th potentiometer holes. After that the step bit makes short work of the footswitch hole and holes for...

Love My Switches and Tayda Electronics both have them. FYI: The Tayda ones have a lot of plastic I am not sure about the LMS ones because I have none on hand ATM.

I drill mine the same way. I found that the step bit is best for jacks and footswitch. I have not looked into these Barber pedals, but I love switches so I probably need to build one.

It gates and splats out into flub but before and after that it sounds great. Nice shimmery enclosure!

Doom! Chug!

Just tried it and felt it in my chest

Yes, they sell completed boards at Tayda about $12- There are tiny SMD LEDs that light up on the board, I would have liked to expose one through the enclosure, but alas, no hole-through. So with these Tayda SMD boards you just need to add the potentiometers, the dipswiitches (optional) and then...

PPCB Enchanted boost Tayda Super Hard On PPCB Micro-clean boost PPCB Fumble Boost PPCB LPB-1

Nice build and I dig the circuit too

a cute dumbo rat

Thanks much! These SMD pre-soldered boards from Tayda sound great! I imagine it would be quick putting them in a 125b but there would be lots of wires.

Thanks, I am not a smart man. I may have to run it a while.

All of my years of playing guitar and I never played with a Rat circuit. Seems like I missed out on a great circuit thinking it was only for distortion. It goes from a great clean boost to a fully saturated distortion pedal: high gain. Since I never played with one I thought my tone...

The 1964 Vibroverb's 15" sounds great and the amp is all original. Most circuits sound great on that amp. As you have said, some components may be out of spec because it has never been serviced. Still has the two prong chord! I think as I said, I was in a bad mood when I tested this circuit: I...

Thanks, I think it sounds amazing at every setting now. Some of my builds do not sound good on the Vibroverb. I have some 62 year old tubes in that thing and it is low, I think the tubes are taxed because it can sound flubby. I am ashamed of myself for writing a review before trying the 65 super...

Yes, perhaps I was in a foul mood and it was coming through my Vibroverb poorly. Single 15”. Sounds terrific on the super reverb.

Ok plugged this in my Super and it was great. I should never do a review off of my Vibroverb alone. It was indeed fantastic. Loads of tone to be had and all of it useable. I see the error of my review @HamishR @bluedmc777

I will snag one and let you know if my ears like it.

Yes, I don’t quite understand it, but it looks like you can still see the bare enclosure just a bit. I definitely would like more.