Search results

I've eyed one of those as well for making my own multi-effect stomp like that. I'll be watching!

I have and use the Irwin ones. Yes they are more expensive but they last long. Even with the non brand name ones I make sure to drill a pilot hole. And if the enclosure is not finished I will use some sort of lubricant. That and go slow, otherwise i tend to gild the aluminum to the bit.

Thanks for the explination!

The voltage regulator? If i remember correctly the charge pump get it to 18volts and the regulator drops it back to 12...

Subsitutions for transistors,jfets,opamps,diodes,etc

I have this one Transistor Tester, DROK Mosfet... https://www.amazon.com/dp/B01MS1FOYM?ref=ppx_pop_mob_ap_share Used it for jfets,transistors, and resistors so far.

I have A tester from amazon and I made a tester from rullywow or madbean and they correspond to each other. I've build two nom-nom phasers from madbean which quad sets that I matched myself. I haven't tried useding matches ones in other pedals but I've wondered about it just like you..

I like the abyss so much that I bought another to build for my smaller pedal board. I'll be finishing the Photon Vibe soon, we'll see if that replaces that. I'm guessing it will.

Nice! I was missing the dual gang pot, so that will be later this week. Glad you like it I'm looking forward to it

nice demo, that first setting is pretty to close to how I've been running mine as well.

Looking at the schematic r23 is 4.7k and r25 is 47k and r24 is 100k and r26 is 100ohm. I could see myself swapping or getting some of those messed up, so maybe start checking there?

I've been running mine for a couple practices now and am still working. Do you have the intensity cranked? I'm wondering if you have a resistor wrong leading to that led that is causing it to get more voltage and burn out?

yup I hit it with clear coat and then baked in a toaster oven at just over 200F for 20mins or so. It did dull out the colors a bit, but it'll keep which is the important part.

Figured this will probably be an always on pedal for me, so I had my son do some drawing on it, and pick out the knobs.

Nice build! glad to see someone put and xlr in one. If I ever build one, I'll do the same.

Thank you both!

I kept forgetting to order the b25k pots for this so I had it almost done for a while. I used a stamper my wife had and my son added the punctuation... Got it wrapped up late last night so didn't get to do much a side from basic testing. I have band practice tonight so I may see if I can get...

nice!

thanks! Just ordered. looks good to me

They are fairly tight, but because of how they taper, I can still use them. They are the Davies 1510 style. The KN1611 that I get from tayda would give the same basic look with more room. It is just a white washer. I have seen the illuminated stomp switch guitarpedalparts.com has them, but I...