Search results

Is it literally middle to middle right to right left to left. Nothing weird? Also would you do a A50K or a B50K?

if I want to not put a 50k internal trim pot for the clean and instead use an external pot can someone tell me how I go from the three holes in the PCB to an external pot? Also for the external pot should it be a A50K or B50k? FYI this is the Sunflower Fuzz

thank you

Right. I have a bunch of the normal size Lumberg DC so I guess I will use my step drill bit to expand the hole until I use all of them

Good point forgot about no metal. Yea I like Lumberg a lot so it sucks Tayda doesnt have the small Lumberg plastic ones. I have a bunch of the normal size Lumberg DC so I guess I will use my step drill bit to expand the hole until I use all of them

I assume this one would work too https://www.taydaelectronics.com/1614-19-lumberg-dc-power-socket.html

Thank you I assume that one has no option for a battery because I dont see a third connection point which is fine as I normally dont put battery clips in my builds

In my last order I order two pre drilled enclosures for my Cobalt Drive builds specifically these Click Here because I figured why have to drill if I can just pay 1-2 dollars more and its all done. The enclosures look great but the hole for the DC power is way too small for the Lumberg DC power...

To set this post up I have built a few Uber Drives aka Boss SD-1 as well as modded real SD-1 which has has 3, see attached picture, asymmetrical clipping diodes. I would like to give the user the option of switching between 2 sets of diodes lets say to keep it easy 3 silicone and 3 germanium...

Thank you all I ordered and got them today

very nice thank you for this link

Thank you I always use Tayda I have never looked at that site.

Can someone please help me. I want to build this Cobalt Drive so bad but I cant find a A250K dual PCB mount pot. How are you guys building these Boss clones as they all seem to have a dual pot that I cant find

Its an easy and cheaper pedal to build so I think next time I will try a 10k internal trim for the bias and still use the 5k for the clean

I built the Sandspur Fuzz which is the BC108 NPN pedal and all went fine doing the bias with the 5K internal trimpot. My issue is I built the Sunflower Fuzz Pedal PCB Sunflower Fuzz after and the bias was not as easy with internal 5K trimpot the build doc called for. I had to turn the internal...

Anyone on how to insulate without the cap

Seems a little better still a bit cooked to the side but not as much. How do I insulate it without the cover on it.

There is not enough space for the B100K potentiometer next to the switch. This is the switch recommended in the build docs so it’s not like I bought the wrong switch or is it just designed to sit crooked like this? Parthenon Page

UPDATE it’s the switch. I took it off and it works. So now to figure out what was wired wrong on the switch.

The issue with the Kliche is the diagram at Schematic is that it is an old version of the board. If you notice under IC3 is a row of 4 caps then 3 caps under it on the schematic but on my version of the board it’s a row of 3 the 4 under it.