Search results

Should preface by saying I've built a few of these and they all worked right out the gate. This one I'm getting sound up to R8 and Pin 5 of IC1. Tried 2 different TL072 and same issue. IC3 gets incredibly hot right away. I get some signal on both Pin 1 of the dual gang gain pot.

Can't see anywhere in the documentation..but can you run a Kliche off 18V? There's a spot in the schematic showing D4 and D5 hitting 18v

Hi! I know there's a lengthy thread about Tayda's UV print service.. I learned a lot from there, thanks to all who posted on that mega thread! I'm in Affinity Designer. I've taken a JPG and vectorized it to a png in inkscape. I then brought that into AD and converted the image to curves. When I...

Question about the UV printing from Tayda. I'm looking to build a Ceasar from Pedal PCB.. I've placed PPCBs template over the Tayda one, and they're a little off from each other. Tayda measures out at 62 x 117mm while PPCB is 64 x 118.5mm My concerns are twofold, one, properly sizing out my...