DailyDovetails
Well-known member
- Build Rating
- 5.00 star(s)
Here is the Unicab I have been working on. I changed a few thing in the design for the case to make the wider board fit in easily and for the bottom to close more flush. I also designed some new knobs that allow me to adjust the pots with the tight spacing from the 6 knob box.
This project went together easily and fired up the first time. I’m still learning to use the pedal as it does a lot but I gives me tons of options to tighten up and color my sound. I really like it so far and could see having it always on. I’m running it in the effects loop of my Boss GL 100 it allows me to turn off the built in cab modeling and makes it much more flexible. This pedal is the last mono pedal before it goes into the stereo section of my setup.
My next project is going to be a Trembling Loon. I’m working on a 3d printed coupler for the LED/LDR and am going to try some artwork as well.
This project went together easily and fired up the first time. I’m still learning to use the pedal as it does a lot but I gives me tons of options to tighten up and color my sound. I really like it so far and could see having it always on. I’m running it in the effects loop of my Boss GL 100 it allows me to turn off the built in cab modeling and makes it much more flexible. This pedal is the last mono pedal before it goes into the stereo section of my setup.
My next project is going to be a Trembling Loon. I’m working on a 3d printed coupler for the LED/LDR and am going to try some artwork as well.