Oh hello, Schematic attached.
I built it, it worked. But I lost track of what the 8 programed effects were for this one. So I was going point to point from the rotary switch source using a wire. Why not use a switch? I actually just want this for one or 2 effects using a toggle switch. And the wire touched the Builder chip on the left side. Legs 1-4. One of them got touched and the build is dead. I replaced the builder chip and still dead. So I'm looking, what else may have been affected. I see 3.3v at the rotary source? Legs 1-4 on the chip all go to ground. What could've happened? Thanks
I built it, it worked. But I lost track of what the 8 programed effects were for this one. So I was going point to point from the rotary switch source using a wire. Why not use a switch? I actually just want this for one or 2 effects using a toggle switch. And the wire touched the Builder chip on the left side. Legs 1-4. One of them got touched and the build is dead. I replaced the builder chip and still dead. So I'm looking, what else may have been affected. I see 3.3v at the rotary source? Legs 1-4 on the chip all go to ground. What could've happened? Thanks