Boost a Drive a Fuzz

[Dostradamas]

I am still weaning off kits but when one comes along I like I grab it.
Rattlecan hammered dark bronze
Upgraded to Lundbergs
Came with a white LED for blinding the user when on
Perfect kit, everything there and planned for with a very nice fit and flow.

I think a tone control would be nice

With the esquire straight in it is as bright as the sun
With P90's in my LP special it lightens a darker guitar perfectly

It does what it says but as many would think none of the three are stellar but all three are solid and usable.

 

[Dostradamas]

So I must amend my first opinions on this cause I am a dumb ass.

I set the bias without the gain knob maxed.

New enough I rolled with it but experienced enough to have a splinter in my mind about it.

Set bias properly and she roars to life.
All three settings sound much better .

Sound clip next

 

[LoudNoises]

I just finished my build on this pedal. Pretty straight forward assembly. I’m getting no tone difference between the drive, boost, and fuzz switch tho, sounds like it’s stuck in boost mode. I ohmed out the mode switch and it seems to be working. Any suggestions?

 

[Dostradamas]

I just finished my build on this pedal. Pretty straight forward assembly. I’m getting no tone difference between the drive, boost, and fuzz switch tho, sounds like it’s stuck in boost mode. I ohmed out the mode switch and it seems to be working. Any suggestions?

Tone wise there isn't much difference in the three.



Boost I like low gain and volume pushed almost all the way with the filter about centered.

Drive I use low volume and max to almost max gain with the filter all the way to the left

Fuzz is best with gain cranked and at least half volume and filter to taste.

 

[LoudNoises]

whew ok I thought it was me. I tried your settings, all sound great. It has a sort of gritty low-fi quality through my Princeton that I really like. Thanks a lot!

 

[jubal81]

Dude, looks damn sweet inside and out. Nice work!

 

[Dostradamas]

Dude, looks damn sweet inside and out. Nice work!

Appreciate it
It is a pre drilled kit so most of the good looks is on them.
The knobs (oh the knobs) they always tug at me so I have these on there right now and that plastic LED bezel had to go


I really like the Warp Pipe bezels