Not a pedal, but not much bigger...
I have a crappy Fender Frontman 15r that I wound up with, and the Treble pot shaft is mostly broken off. I'm going to get a close-enough witch hat knob from AES, but the knurled, plastic shaft is just a stump. Insert joke here.
I had put a bit of stiff tubing into a chicken head knob and shoved that onto the stump, but now that I'll be getting a better knob I'd like to figure something else out. I'd replace the pot, but don't know the value of the Treble control. Finding an original seems tough, outside of spending 60 bucks for another 15r! The pots look like kinda like this, although I haven't opened it up to see the base yet:
I could possibly drill a tiny hole in the stump and glue a brace in there, but I'm not sure what I'd use to "create" the missing shaft piece before gluing it on. Don't have access to 3D printing. This all seems like a HUGE waste of time, but for reasons unknown I want to finally "fix" some of my old, junky amps.
I have a crappy Fender Frontman 15r that I wound up with, and the Treble pot shaft is mostly broken off. I'm going to get a close-enough witch hat knob from AES, but the knurled, plastic shaft is just a stump. Insert joke here.
I had put a bit of stiff tubing into a chicken head knob and shoved that onto the stump, but now that I'll be getting a better knob I'd like to figure something else out. I'd replace the pot, but don't know the value of the Treble control. Finding an original seems tough, outside of spending 60 bucks for another 15r! The pots look like kinda like this, although I haven't opened it up to see the base yet:
I could possibly drill a tiny hole in the stump and glue a brace in there, but I'm not sure what I'd use to "create" the missing shaft piece before gluing it on. Don't have access to 3D printing. This all seems like a HUGE waste of time, but for reasons unknown I want to finally "fix" some of my old, junky amps.