Svenson007
Active member
Hey guys. This has been a rough build. My first mistake was rushing and assuming. I though all the 1u capacitors were actually 1nf box caps. It just didn’t register that it wound be 1uf ceramic. The space allowed looked perfect for 1nf film caps….. not a 1uf. So I used all 1nf box caps…….. shit
So I had to desolate those. Don’t think I lifted a pad or anything…. I hope….. Got the right caps replaced.
Then I soldered a pot facing the wrong way. Desoldered that and screwed up a pad for pin one. Got it back in and followed the trace so I could route pin one of the mix pot to the correct place (Rate pin two) So that was wired up and fixed.
I finish the rest and get it wired up to test.
Everything works (modulation etc)except there is only one repeat. One delay. The last time this happened was deep blue delay. I didn’t have a 22nf populated yet.
One thing I noticed, if I wire between lug three of time and repeat it will give me some delay repeats. The delay can be adjusted a bit but it’s not right (wired not soldered for testing). It will oscillate easily… etc. Then I fooled around trying to trace my way around looking for the problem. But it’s way over my head. I’ll attach some pics. Again everything works expect I only get one repeat. Pleeeaseeeeeee help.Sorry that was long winded!
So I had to desolate those. Don’t think I lifted a pad or anything…. I hope….. Got the right caps replaced.
Then I soldered a pot facing the wrong way. Desoldered that and screwed up a pad for pin one. Got it back in and followed the trace so I could route pin one of the mix pot to the correct place (Rate pin two) So that was wired up and fixed.
I finish the rest and get it wired up to test.
Everything works (modulation etc)except there is only one repeat. One delay. The last time this happened was deep blue delay. I didn’t have a 22nf populated yet.
One thing I noticed, if I wire between lug three of time and repeat it will give me some delay repeats. The delay can be adjusted a bit but it’s not right (wired not soldered for testing). It will oscillate easily… etc. Then I fooled around trying to trace my way around looking for the problem. But it’s way over my head. I’ll attach some pics. Again everything works expect I only get one repeat. Pleeeaseeeeeee help.Sorry that was long winded!
Last edited: