Musicjsmith
Well-known member
A while back I found this circuit as a search for the Electra. It is simple and tweakable, but I decided to build it stock and then go from there.
The build documents are not complete so I used the schematic for the Je T’aime with just a couple values different.
It only has one knob so I used the hole pattern from the Cleaver boost circuit (or any other one knob build), but then I needed two switches. I used the pattern from the Dirt Dauber for that drill pattern. It all fits fine but there is not a ton of room for the switch wiring if you use a switch PCB.
Since it’s the Dielectric, I went with the local power lines in my neighborhood. I might switch out the know. I found an old knob off who knows what in my high school band room that looks about perfect. It’s just missing the set screw.
The build documents are not complete so I used the schematic for the Je T’aime with just a couple values different.
It only has one knob so I used the hole pattern from the Cleaver boost circuit (or any other one knob build), but then I needed two switches. I used the pattern from the Dirt Dauber for that drill pattern. It all fits fine but there is not a ton of room for the switch wiring if you use a switch PCB.
Since it’s the Dielectric, I went with the local power lines in my neighborhood. I might switch out the know. I found an old knob off who knows what in my high school band room that looks about perfect. It’s just missing the set screw.
