Electrovibe drill template question

[Locrian99]

I’m sure this is asked somewhere but I did t see it quickly.


I was planning on using a normal spdt switch for the chorus vibrato mounted to the board. Looking at the template it appears that won’t work following the template.

1 am I correct in my thinking.
2 anyone know how much lower than the switch hole to make it.

Thanks.

 

[DGWVI]

The drill template will work perfectly, if your using the standard SPDT toggle - My build report, using a toggle

 

[Locrian99]

The drill template will work perfectly, if your using the standard SPDT toggle - My build report, using a toggle

It doesn’t look like you mounted it to the board it looks like you ran wires to it? Am I looking at it wrong ?

 

[DGWVI]

It doesn’t look like you mounted it to the board it looks like you ran wires to it? Am I looking at it wrong ?

Correct. That's how it's shown in the drawing as well -

 

[Locrian99]

Correct. That's how it's shown in the drawing as well -
View attachment 50047

Yea that’s what I meant was if I mount it to the board rather than doing off board wiring.

 

[DGWVI]

Yea that’s what I meant was if I mount it to the board rather than doing off board wiring.

Ah, yeah. You'll have to wire it off board to fit the template. The standard toggle is too big to board mount, anyway

 

[Locrian99]

Ah, yeah. You'll have to wire it off board to fit the template. The standard toggle is too big to board mount, anyway

Ah guess I hadn’t even looked at that