Flat Blade Solder Tip

[DeadAirMD]

Does anyone know where to get one of these Flat Blade Soldering Iron tips from? I think that's what they're called. I also think my soldering iron uses tips that are 900M-T, so the tip itself needs the inside to be open so I can slide it onto my soldering iron.

 

[benny_profane]

@Robert can link you one. They cost a bazillion dollars.

 

[fig]

"Wide chisel"

They take awhile to heat/recover, but will pull an smd transistor (or a POT cleanly.

 

[Robert]

I've never seen one in the standard Hakko tip style, only the hotswappable type with integrated heating element.

This is the one I use in my Pace station, but of course, you'd need the compatible Pace ADS200 station to use it.

https://www.tequipment.net/Pace/1130-0501-P1/Tips/

Hakko makes one, but it's also for their hotswappable station.

A bit pricey but worth every penny. It can pull pots, toggle switches, pin headers, whatever.

 

[jwin615]

Copper wire works too. 14 ga or so, form it around the pads, tack each pin on the far end, then the ones in the middle. Heat it with a hot broad tip and wait for gravity to work