Mike McLane
Active member
I got your High Voltage PSU and have a couple of questions:
1. Heater leg is 6.3vdc, therefore (+) to pins 4&5 and (-) to 9?
2. You have two 9vdc & Grd eyelets side by side. Is one to provide a 9vdc leg to operate LED's?
3. As far as ON and OFF is concerned would you effect that simply by using a foot switch ground the signal at the Volume control?
1. Heater leg is 6.3vdc, therefore (+) to pins 4&5 and (-) to 9?
2. You have two 9vdc & Grd eyelets side by side. Is one to provide a 9vdc leg to operate LED's?
3. As far as ON and OFF is concerned would you effect that simply by using a foot switch ground the signal at the Volume control?