I have my board at the stage where all the parts are in and I can listen to it.
It nails the sound Page gets. However, I found myself thinking it didn’t have enough bass so I replaced the 2.2uF bypass caps with 4.7uF caps as recommended here. Thanks for the tip by the way.
I wasn’t fond of the 100K log filter pot at the input, the cut end is pretty bunched up. I put a linear pot in and liked it better.
I’m thinking that I would like more range in the bass cut, maybe a 470 or 1000pF?
I was thinking the same thing about the treble response. There is a 3.3nF cap to earth shunting highs. That too could have a pot to add more highs. I think it would be too raspy without the cap, but the right value pot might be a good thing.
Any thoughts?
Regards
Mark
It nails the sound Page gets. However, I found myself thinking it didn’t have enough bass so I replaced the 2.2uF bypass caps with 4.7uF caps as recommended here. Thanks for the tip by the way.
I wasn’t fond of the 100K log filter pot at the input, the cut end is pretty bunched up. I put a linear pot in and liked it better.
I’m thinking that I would like more range in the bass cut, maybe a 470 or 1000pF?
I was thinking the same thing about the treble response. There is a 3.3nF cap to earth shunting highs. That too could have a pot to add more highs. I think it would be too raspy without the cap, but the right value pot might be a good thing.
Any thoughts?
Regards
Mark