A antonkova New member Apr 6, 2025 #1 I have just completed Meridian Build and I like this compressor very much. I went through the posts and I just can't figure out how to set the Bias trimmer pot. Please advise
I have just completed Meridian Build and I like this compressor very much. I went through the posts and I just can't figure out how to set the Bias trimmer pot. Please advise
L lowpitch Well-known member Apr 6, 2025 #2 Here's some info: https://forum.pedalpcb.com/threads/ami-spirit-of-76-median-compressor.22924/#post-303001
Here's some info: https://forum.pedalpcb.com/threads/ami-spirit-of-76-median-compressor.22924/#post-303001
A antonkova New member Apr 6, 2025 #3 thank you, If I understand correctly, trim pot shoud set Drain of Q1 to1.875VDC, measured between pins 2 & 3 (Source and Gate),
thank you, If I understand correctly, trim pot shoud set Drain of Q1 to1.875VDC, measured between pins 2 & 3 (Source and Gate),
L lowpitch Well-known member Apr 6, 2025 #4 antonkova said: thank you, If I understand correctly, trim pot shoud set Drain of Q1 to1.875VDC, measured between pins 2 & 3 (Source and Gate), Click to expand... Best ask @andrewsrea, as he's done a bit of a deep dive on the circuit from what I can tell.
antonkova said: thank you, If I understand correctly, trim pot shoud set Drain of Q1 to1.875VDC, measured between pins 2 & 3 (Source and Gate), Click to expand... Best ask @andrewsrea, as he's done a bit of a deep dive on the circuit from what I can tell.
