New v2 Muffin factory parts list

[Jbanks]

So I know that the DIP switches have changed to 4 of the 5 switch DIP’s. It appears the 4 10 pin outs are the same for the DIP switches. Is there anything else different from V1?

Also, are the 2 SPDT switches for Si/GE or Si/LED just on/on? The BoM only lists the 3 DPDT switches.

Thanks,
James

 

[Robert]

I'll get it posted in just a bit. There are a few additional parts, but nothing major.

The SPDT's should be On/Off/On.

 

[Jbanks]

Ok. I’ve soldered in the components but clueless how the DIP switch’s 1) reach out wide enough to the socket holes-do I have to angle the sockets inward?

2) how do the 2 5 switch DIPs both fit on the socket (10 slots for 2 5-pin switches) with the v2 gap between every 5 DIP’s.

Probably should wait for the build docs.? noticed there are some resistor changes as well.

 

[Robert]

You were supposed to get a dipswitch adapter board with the Muffin Factory PCB, did you not receive one of these?

 

[Jbanks]

Oh I see. It all sits on top. I’m so dumb. Thanks. Also are the DPDT on off on? Or On on on?

 

[Robert]

If you use the faceplate you can ignore the labels on the adapter module, those are for when you mount the dipswitches internally.
The notch in the adapter board is for access to the LED pins when soldering.

The DPDTs are two position ON/ON.

I'll try to get the drill template wrapped up and posted ASAP.

 

[yanivt]

Hi,
Any ETA on the latest Muffin Factory build doc and drill template?
Thanks!

 

[chongmagic]

I think most of the values are silk screened on the pcb if that helps.

 

[MR909]

Hi am after the V2 parts list/drill template too

 

[Robert]

Updated build docs are posted now.

 

[K Pedals]

Updated build docs are posted now.

The drill template on the new one is the same as the old one I think...

 

[Robert]

Good catch, updated. =)