No distortion from Muroidea Pedal

Jopat1085

New member
Hey guys,

First time builder and started with the Muroidea (Rat) pedal. Just finished with everything and the pedal works. All knobs seems to be working but there is no distortion. It sounds almost like a boost pedal but a little weaker. What can I check for?

I’m very new to building but am genuinely interested in learning as much as I can. I can put together an Audio Probe but I don’t necessarily know how to use it. I have very little knowledge with any of this but am learning slowly.

Thanks for any help!
 
First step would be to post pictures of both sides of the PCB (if possible). Make sure to including jacks/switches to we can double-check the wiring too.
 
Check the value of these resistors. It looks like several might be incorrect.

It looks like:
560K where 560R (560 ohms) should be.
470K where 570R (470 ohms) should be.
1 ohm where 1K should be (in two places)
1.5 ohm where 1.5K should be


1656689728927.png
 
Loks
Check the value of these resistors. It looks like several might be incorrect.

It looks like:
560K where 560R (560 ohms) should be.
470K where 570R (470 ohms) should be.
1 ohm where 1K should be (in two places)
1.5 ohm where 1.5K should be

Yeah, I don’t know how I got all those wrong. I’m gonna go back through those now.
 
Back
Top