VanWhy
Well-known member
I know I know. I only got this since it was the only DIY board out there. So everything works fine. I had to make a couple tweaks per the effectslayouts blog.
Anyway, the LED is not working at all. When I hook my DMM up to the LED it lights. But when it's connected to the board, nothing. Looking at the schematic, I don't see a current limiting resistor. So I added one and still nothing. I tried going from the CTRL pad on the board from positve LED+CLR and negative to CTRL on the footswitch. Still nothing.
I see D3 on the schematic but I can't tell where it's going. I could use another set of eyes when someone has the time. Attached is the schematic and a shot of one point of the build. This one has a CLR attached but only after I tried it without.
Thanks.
Anyway, the LED is not working at all. When I hook my DMM up to the LED it lights. But when it's connected to the board, nothing. Looking at the schematic, I don't see a current limiting resistor. So I added one and still nothing. I tried going from the CTRL pad on the board from positve LED+CLR and negative to CTRL on the footswitch. Still nothing.
I see D3 on the schematic but I can't tell where it's going. I could use another set of eyes when someone has the time. Attached is the schematic and a shot of one point of the build. This one has a CLR attached but only after I tried it without.
Thanks.