PedalPCB "3 Series"

ClippyTheDiode

Well-known member
Here is my take on a hypothetical "PedalPCB 3 Series". A low cost set of classic pedals using only 3 knobs, and pre-drilled powder coated enclosures from Tayda.

Try to guess:
Black = Muroidea (Rat)
Green = Little Green Scream Machine (Tube Screamer)
Yellow = UberDrive (Boss SD-1)
Blue = Cobalt Drive (Boss BD-2)
(highlight for answers)

I think I should add a Muffin Fuzz in red. (Then I can form Voltron)
 

Attachments

  • 20230419_172619.jpg
    20230419_172619.jpg
    456.2 KB · Views: 95
  • 20230516_160321.jpg
    20230516_160321.jpg
    485.1 KB · Views: 82
  • 20230527_175711.jpg
    20230527_175711.jpg
    461.1 KB · Views: 76
  • 20230531_122421.jpg
    20230531_122421.jpg
    473.7 KB · Views: 90
  • 20230531_122647.jpg
    20230531_122647.jpg
    302.3 KB · Views: 92
Are you saying that JHS has knocked off someome elses designs with this range? ;)
Well I wasn't trying to throw any shade at JHS. But they were an inspiration for the name.

Side note, the Blue housing was originally going to be a "Blue Breaker", but I realized I had a "Glory Hole" in the works which is basically the same pedal with an output buffer. So I changed directions and went with the "Cobalt Drive" instead.
 
Another addition to the family. This is a Muffin Fuzz built mostly to the triangle BOM. I substituted a couple capacitor values, and used A taper pots on sustain and volume. Linear pot on Tone.

Queue the music baby, we forming Voltron!
 

Attachments

  • 20230629_143945.jpg
    20230629_143945.jpg
    575.6 KB · Views: 35
  • 20230629_144005.jpg
    20230629_144005.jpg
    343.7 KB · Views: 35
  • voltron.jpg
    voltron.jpg
    453.5 KB · Views: 35
Back
Top