I made this drill template for the Cleaver V2 boost.
Caveats:
- UNVERIFIED
- I used the worst tools (paper, ruler, two scale factors to calculate)
- I have been known to make careless errors
- my dimensions for LED and power jack holes may not match yours
It would be super cool if someone could verify. I think it’s at least close (I’m most worried about the distance from the center of the pot to the center of the switches which might be off by as much as a mm on the Y axis). @Robert - thoughts?
Caveats:
- UNVERIFIED
- I used the worst tools (paper, ruler, two scale factors to calculate)
- I have been known to make careless errors
- my dimensions for LED and power jack holes may not match yours
It would be super cool if someone could verify. I think it’s at least close (I’m most worried about the distance from the center of the pot to the center of the switches which might be off by as much as a mm on the Y axis). @Robert - thoughts?
Last edited:
