REQUEST Pedalpcb - Pipe Stretcher

[FormulaFourteen]

Anyone got a Tayda drill template for the Pipe Stretcher?

Its three knobs and a switch so I suspect a "standard" layout but I couldn't find an "official" template in the various bits of documentation.

Thanks!

 

[FormulaFourteen]

Hey @Robert (or anyone else)

You don't need to supply a full template (I can modify another one) but can you tell me the correct way to work out the spacing of the toggle relative to the pots?

I'm assming the Pipe Stretcher is a "standard 3 knob" so the pots are just in those positions, right?

Thanks!

 

[Barry]

That looks correct, just put the switch on the same center lines as the volume and tone pots.

 

[Erik S]

I punched and drilled off the paper template and everything fit right.

You could print and measure off that to verify.

https://docs.pedalpcb.com/project/PipeStretcher.pdf