OD is Glorious
Well-known member
- Build Rating
This is my sixtieth build... still working my way through the PPCB reverb offerings. This one has some functionality. It works - and is not too "horror-movie-crazy". The FV-1 was soldered in at PPCB and the rest was soldered by me. The pedal was a pleasure to assemble and I enjoy the result. I am a fan of traditional reverb, and this one can go beyond it a bit. it utilizes an SPDT on/off/on to switch modes and five potentiometers to dial in your preference.
I chose a white enclosure from Tayda with 15mm aluminum knobs. Switchcraft jacks and a 1kg foortswitch, The 5mm LED bezel from Stompbox is one of my new favorites for a clean low profile look - 1/4 inch hole, Using this bezel allows yu to use non-diffused bulbs. I am always thankful when one of these FV-1 pedals gets together and work. I attempt tp do the math and it is just $36 for the board and FV-1! Once you add up time and parts these are pricey pedals.
Enclosure $10
Board FV-1 and EEPROM $36
Switchcraft jacks $6
D.C. jack $1
Potentiometers $5
Knobs $10
Footswitch and breakout $4.50
Various other components $7
I chose a white enclosure from Tayda with 15mm aluminum knobs. Switchcraft jacks and a 1kg foortswitch, The 5mm LED bezel from Stompbox is one of my new favorites for a clean low profile look - 1/4 inch hole, Using this bezel allows yu to use non-diffused bulbs. I am always thankful when one of these FV-1 pedals gets together and work. I attempt tp do the math and it is just $36 for the board and FV-1! Once you add up time and parts these are pricey pedals.
Enclosure $10
Board FV-1 and EEPROM $36
Switchcraft jacks $6
D.C. jack $1
Potentiometers $5
Knobs $10
Footswitch and breakout $4.50
Various other components $7
