Pot form factor for PedalPCB boards?

[ThermionicEmissions]

I'm looking at ordering a couple of PedalPCB boards (the Angry Charles, and the Mach 1 Overdrive), and it's not clear to me which pots I should get. I know they need to be PCB mount pots with right-angle legs, and I believe 16mm pots have the correct leg spacing, but what I haven't been able to find out is recommended specs for shaft length and leg length. Up 'til now I've only used pots with solder lugs so this board mount thing is new to me.
Anybody have any recommendations? I source my parts from either Nex Gen Guitars (Canada) or Tayda.
Cheers!

 

[Erik S]

This size-spec is what you want.

https://www.taydaelectronics.com/p-100k-ohm-logarithmic-taper-potentiometer-round-shaft-pc-mount-5707.html

And get some dust caps while you’re at it.

 

[ThermionicEmissions]

This size-spec is what you want.

https://www.taydaelectronics.com/p-100k-ohm-logarithmic-taper-potentiometer-round-shaft-pc-mount-5707.html

And get some dust caps while you’re at it.

Perfect, thanks! I guess the pots with the longer legs are to provide more clearance for taller components.
I've got lots of 16mm dust caps, but good to mention it.

 

[LukeFRC]

Perfect, thanks! I guess the pots with the longer legs are to provide more clearance for taller components.
I've got lots of 16mm dust caps, but good to mention it.

Components are on other side of board typically. But leaves a wee gap to stop anything shorting

 

[ThermionicEmissions]

Components are on other side of board typically. But leaves a wee gap to stop anything shorting

Oh, duh! Of course! That took me way too long to figure out.

Thanks!

 

[Alan W]

Sometimes if I’ve vertically reconfigured a knob location I’ll use a longer legged version to allow for the move. If it’s more than that allows, I just add wires.

I’ve also specifically ordered long lead pots if the shorter lead ones are not available, but it’s finicky trimming them to length.

 

[ThermionicEmissions]

Sometimes if I’ve vertically reconfigured a knob location I’ll use a longer legged version to allow for the move. If it’s more than that allows, I just add wires.

I’ve also specifically ordered long lead pots if the shorter lead ones are not available, but it’s finicky trimming them to length.

Thanks for the input!