I know sounds like a stupid question, but has anyone confirmed the Engineers Thumb build??
I built one up. Seems to work and all controls, but active LED is either ON....or ON brighter/darker!!
Just so I know when on or off, just disconnected the 2 wires from the board, and wired hot directly to the LED and ground to the switch, then switch thru current limiting resistor to LED!!
Just wanted yo throw this out there as shouldn't have had to do this and everything seems fine as controls are working, didn't see any solder bridges or anything, so didn't get why the issue, but wanted to report it!!
I built one up. Seems to work and all controls, but active LED is either ON....or ON brighter/darker!!
Just so I know when on or off, just disconnected the 2 wires from the board, and wired hot directly to the LED and ground to the switch, then switch thru current limiting resistor to LED!!
Just wanted yo throw this out there as shouldn't have had to do this and everything seems fine as controls are working, didn't see any solder bridges or anything, so didn't get why the issue, but wanted to report it!!