moltenvolta
New member
Just bought the 125B enclosure drill template and was wondering how to know which hole spacings to use for each different type of enclosure (3 knob type 1 vs 5 knob type 1 vs 5 knob type 2 vs 4 knob type 1, etc).
Also, the Circulator has a tag that just says 125B but when looking at the drill template in the build docs it looks like the holes are a bit closer to the edge of the enclosure compared to say the Sherwood Drive...Is it safe to assume that any PCB that has a pot or toggle switch in the middle area, between two outer pots, will require the 1.6" spacing, while the 3 knob type 1, 2 knob type 1, and 4 knob type 1 all use the 1.3" spacing?
Also, the Circulator has a tag that just says 125B but when looking at the drill template in the build docs it looks like the holes are a bit closer to the edge of the enclosure compared to say the Sherwood Drive...Is it safe to assume that any PCB that has a pot or toggle switch in the middle area, between two outer pots, will require the 1.6" spacing, while the 3 knob type 1, 2 knob type 1, and 4 knob type 1 all use the 1.3" spacing?