KT88 Active member May 6, 2024 #1 If I want to omit the rate LED (bottom pads), do I just leave it unpopulated or does it need a jumper? Attachments 1715048308592.png 305.9 KB · Views: 72
If I want to omit the rate LED (bottom pads), do I just leave it unpopulated or does it need a jumper?
Brett Well-known member May 7, 2024 #2 Looks like the bottom pads are for the regular LED. I think you could omit the rate if you wanted. You could also mount it on the component side (instead of through the front panel) if in doubt.
Looks like the bottom pads are for the regular LED. I think you could omit the rate if you wanted. You could also mount it on the component side (instead of through the front panel) if in doubt.
