[SOLVED] Gain knob not responding on Oasis (Dunes)

[GregDS]

Hi everyone, this is my first post here,
I built a Oasis today but the gain knob seems to be stuck on a certain value. Turning it has no effect on the amount of clipping, I just get a very soft overdrive.
I measured the value of the gain knob (on the circuit but I mostly wanted to see if it was doing its job) and the value is changing as I turn the knob like it's supposed too.
Populated the PCB went smooth, except maybe for the D5 (the LED) because the cathode/anode orientation got me a little confused and I had to remove it and put a new one in the orientation. Could it be something there?
If you guys have any input on where I should start looking, shoot!
thanks a lot

gregDS

 

[Nostradoomus]

Should be in the options...the three little dots on your post, bottom left by the Report button...if you’re on a phone anyway, haven’t looked at this site on a computer haha.

 

[Chuck D. Bones]

FYI, Electronic Goldmine (no affiliation, yadda yadda yadda) has Kemet 47pF caps: 100 for $2.00. I'm getting some, it should be a lifetime supply for me.

 

[Nostradoomus]

Oh hell yeah!